Comment on Modernizing the best Woodworking Joint to use for 3D Printing
SzethFriendOfNimi@lemmy.world 6 months agoI was wondering about that. Considering with ABS a little acetone makes a stronger overall part.
I was thinking maybe the dovetail would be good in that situation for strength but maybe something like a biscuit or peg and hole as mentioned is better?
mipadaitu@lemmy.world 6 months ago
I think the video is better as a way to show some design techniques, than as a demonstration of dovetails as a connector.
That being said, if you didn’t need a permanent connection, it does seem like a decent way to make something that can come apart easily. Wondering how strong it would be after multiple assembles and disassembles.
nilloc@discuss.tchncs.de 6 months ago
I’ve done some dovetails for a puzzle design before. They were meant to assemble and disassemble in multiple orientations.
Depending on the late line directions the problem I had was getting the fit tight enough to not fall apart, but not too tight to remove. I abandoned it because PLA also absorb water and they became stuck after sitting in humidity for a few days.