Comment on [ISSUE] Layer is closer at one end than other
QuarterSwede@lemmy.world 8 months agoIt was leveled pre-printing and with a heated bed. Could still be a level issue because I don’t have ABL but I’m not a noice to leveling.
Print came out great regardless. Also, not my model.
SzethFriendOfNimi@lemmy.world 8 months ago
Same amount of grab to the paper in the center? Wondering if it’s warped? That was such a huge pain for me with mine.
QuarterSwede@lemmy.world 8 months ago
Yep. I’ve got some gcode that automates it. Nice grab dead center and in each corner.
SzethFriendOfNimi@lemmy.world 8 months ago
Ahh. May be physical then. I do have a longer write up I did for somebody else who was having issues who was running Klipper I can link to shortly.
But basically it may be worth making sure everything is solid physically. E.g. extrusions are square, not overly tightened, vwheels are tight enough without being so tight that they end up having bumps and presenting weird issues like this.
SzethFriendOfNimi@lemmy.world 8 months ago
Something else to check… print a small calibration cube. Because I’m wondering if you’re getting consistent extrusion. Inconsistent extrusion along the same plane and height on the cube will be pretty obvious.