Comment on Why do my TPU prints look like this?
tenzen@lemmy.ca 1 year ago
I had similar messy results at one point – it tuned out to be a bad zOffset. Having said that, my part also as a messy top layer – not sure if yours has that or not with the little nub there.
rikudou@lemmings.world 1 year ago
No, that nub is not on the head, it’s slightly beyond, this is due to the angle. The z offset works for PLA, I assume I don’t have to change it for TPU?
tenzen@lemmy.ca 1 year ago
Yeah. If you are good for pla, it’s not likely the cause.