Comment on Major issues with klipper and bed levelling
ShepherdPie@midwest.social 9 months agoLooks like you have it set to load the profile “default” instead of “bed60”
Also worth asking, did you have your start gcode set in your slicer previously and if so, did you delete it out of there now that you’re using klipper macros?
Grippler@feddit.dk 9 months ago
Yeah forgot that I switched to default again to make sure it wasn’t something with the different profiles messing it up. I manually update the mesh before every print now.
I did have my start gcode in the slicer before, but that’s been replaced with the macro.
ShepherdPie@midwest.social 9 months ago
I’ll try to check mine when I’m back home later. I just use the default profile since I don’t ever adjust anything with the bed unless it’s out of spec. Even printing at slightly different temps doesn’t seem to affect anything as far as bed leveling is concerned.
Grippler@feddit.dk 9 months ago
Yeah I’m not seeing any significant deviations in the mesh based on temps either.