Comment on Upgraded Ender 3v2 Issues

pig_master@lemmy.world ⁨1⁩ ⁨year⁩ ago

• xzot746@sh.itjust.works ⁨1⁩ ⁨year⁩ ago

  I did a probe accuracy test yesterday, 0.002. So I think it’s good.

  I have the entire printer torn right back to square one. Will double check everything as I reassemble.

  Did a couple prints yesterday with no BL touch, bed level the four corners, seemed good a bit of first layer micro adjustments.

  Went to perform another print (same as the previous print) and the bed was out of whack again. The bed level test said that the right side was out half a turn on the knobs.

  I’m starting to think it has to do with the dual z motors and not staying timed or level with each other.

  Will see how it works once I get it all back together.

  Thanks.

  source