Comment on An "almost" perfect first layer help

Shadow@lemmy.ca ⁨1⁩ ⁨year⁩ ago

• ArtVandelay@lemmy.world ⁨1⁩ ⁨year⁩ ago

  I know it’s hard to see in the picture, but this is actually dual color filament and the layers are actually almost perfect. The black you see between the white is actually black filament extruded when the head goes the opposite direction. I hope that makes sense. The only spots it was missing were the random lines in the picture.

  source

  • Shadow@lemmy.ca ⁨1⁩ ⁨year⁩ ago

    Hmm. Even still, it looks way too high. Your outside edges look like rounded lines. They should be flat.

    If you peel up that first layer, can you see between the lines at all? It should be a solid sheet of plastic, even just the first layer.

    source
  • callcc@lemmy.world ⁨1⁩ ⁨year⁩ ago

    Still too high I think, even when seeing the two colors now.

    source
  • Contramuffin@lemmy.world ⁨1⁩ ⁨year⁩ ago

    Hmm… I would still guess that it’s the height. Try using the auto-home, then go to move > Z axis and lower the Z to zero, then turn off the motor. If you put a sheet of paper between the nozzle and the bed, how much friction do you feel? You should be able to distinctly feel the texture of the paper, but you should still be able to move the paper around with too much force. If that’s not the case, you should try lowering the Z offset and try again until you get the friction just right, consistently, without needing to make adjustments

    source
  • Aux@lemmy.world ⁨11⁩ ⁨months⁩ ago

    It’s easy to see. You have three perimeters made with the same colour. And there’s a gap between them.

    source
  • deFrisselle@lemmy.sdf.org ⁨11⁩ ⁨months⁩ ago

    Nope, look at it blown up Nozzel is way too high You can see the bed through the lines Plus you have a few broken lines, likely lifted as the extrusion is to far from the bed The lines need to be short and wide not tall and thin

    source
• callcc@lemmy.world ⁨1⁩ ⁨year⁩ ago

  Exactly that. The first (and other filled layers) should have no gaps between lines. They only stick well if they are nicely pushed onto the bed.

  source
• dmention7@lemm.ee ⁨1⁩ ⁨year⁩ ago

  100%

  The good news is that it looks pretty uniform front to back, so the bed is actually probably close to level despite z offset being too high.

  I’m actually kind of impressed with how well the lines are sticking despite how little contact area there is!

  source