Comment

Even if you do wear out your nozzle slightly it probably still works perfectly fine if you change nozzle size/line width in the slicer. I printed a bunch of cf-asa on a brass nozzle since my hardened steel one hadn’t arrived yet. Started out as a .4 but became a .8 nozzle after about 500 grams of printing.

source

Sort:hotnew top

pelespirit@sh.itjust.works ⁨1⁩ ⁨year⁩ ago
That’s good to know, I guess I have to start measuring the width now. I didn’t even think to get one of those measuring devices. Thanks.

source
- TwanHE@lemmy.world ⁨1⁩ ⁨year⁩ ago
  Don’t need to measure, just increase the size by .1 when the extruded lines aren’t flattened out by the nozzle anymore. It’s not a foolproof strategy but might save you from wearing out multiple nozzles instead of 1
  
  source
  - pelespirit@sh.itjust.works ⁨1⁩ ⁨year⁩ ago
    Thanks again, very helpful.
    
    source