Comment

It looks like it’s happening at about the area of steepest overhang. Is it possible the bead of filament is not grabbing onto the previous layer and dragging/sagging?

Maybe try slowing down the print speed a bit and/or increasing fan speed.

source

Sort:hotnew top

callcc@lemmy.world ⁨1⁩ ⁨year⁩ ago
I’d think it’s the overhangs as well. Try reducing layer height or increasing extrusion width. The ratio of those determines the max overhang angle.

source
thegreekgeek@midwest.social ⁨1⁩ ⁨year⁩ ago
It’s definitely sagging, this happened as I was composing the OP:

Image

That’s the worst I’ve seen, usually it’s like the original picture… Oh damn I just noticed it happens at the same layer heights every time.

Image

Hmmm, so why would this filament give me trouble and not the other one?

source
- dmention7@lemm.ee ⁨1⁩ ⁨year⁩ ago
  I second callcc’s suggestions. I don’t think it’s a slicer or hardware issue, just optimizing your print parameters for the filament.
  
  source
thegreekgeek@midwest.social ⁨1⁩ ⁨year⁩ ago
Yeah, looking at the suggested print settings for vase mode makes me think I’ll need to mess with the temp and speed. I kept them mostly the same as my non vase mode profile which is probably is the issue.

source