So then it doesn’t work across the ubiquity switch just to double check? If so, you will need to enable jumbo frames on that for sure and it is not enabled by default and that could also explain the throughput as it is having to fragment then defragment the frames to cross the switch or iperf is using MSS to determine that it can only send 1500 byte frames, your slower speed is about line rate for 1500 byte frames no matter the speed of the actual link.
Comment on Weird 10Gbe networking problems
tmjaea@lemmy.world 11 months agoIt’s just two switches.
Server 1 — 10Gbe — ubiquity switch — 10Gbe — qnap switch — 10Gbe — server 2.
bigredgiraffe@lemmy.world 11 months ago
tmjaea@lemmy.world 11 months ago
Yes,
It does not work. Additionally, the ubiquity switch does not sync with 10gbit/s to one of the qnap switches (I tested with different cables and ports, but the led on the qnap stays orange, indicating connection speed lower than 10gbit/s)
As I’m maybe returning the switch due to the problems I hesitate to register it to access settings. Jumbo frames settings could actually be the solution. But with the problem mentioned in the first paragraph I’m not sure. A 300€ device should just work IMHO…
Thanks for the suggestion with ping, I will test it.
perslue@lemmy.ca 11 months ago
I’ll ask some basics:
Is the ubiquity switch the flex-xg? Make sure you’re using the 10G ports as the poe port is only 1G.
I’m assuming all the ethernet cables are rated for 10G?
Are any of the switches or NICs manually configured to negotiate at a lower transmit rate?
That’s all I’ve got, good luck.
tmjaea@lemmy.world 11 months ago
Thanks for your input. All criteria you mentioned are met.
If I build the same connection with the second qnap switch instead of the ubiquity it is working flawlessly.