Comment on Wireguard easy and third party von service.
LetchLemon@lemmy.blahaj.zone 2 days agoThats probably where im having the issue then thanks for the heads up.
Comment on Wireguard easy and third party von service.
LetchLemon@lemmy.blahaj.zone 2 days agoThats probably where im having the issue then thanks for the heads up.
dan@upvote.au 2 days ago
iptables should still work, but these days it gets converted to nftables so you may as well just learn nftables.
Having said that, I find it a pain to manually configure iptables or nftables. There might be a better way to do what you want.
LetchLemon@lemmy.blahaj.zone 2 days ago
Ahh good so im not just me its actually a bit of a headache. The more i talk to folk the more i feel headscales orobably going to be the way. And rely on folk smarter than i to implement the nftables. Atm im kinda doing a hamfisted approach as the two programs i am using 1 uses nftables and thebother iptables so im already making it hard for myself. Thanks so much this is the kind of clarity i was seeking.
Jason2357@lemmy.ca 1 day ago
I run head scale on a Vps and it has been 100% reliable and provides an exit node for me via that VPS. But you are going to have the exact same issue, I think with your VPN.
You want your default route from the exit node to go over mullivard’s interface, but you need wireguard or tailscale to talk to the other clients directly, via their clearnet IP. You can tell the exit nodes tailscale/wireguard client to bind the clearnet interface, but that may or may not help. Mullivard probably takes the default gateway, which will likely cut off the clients. You could set dedicated routes to the IP addresses of the clients, but they can change if those clients are mobile. You will need to maintain a routing table somehow or keep the pre-existing connection active (fragile).
I am sure its well trodden ground, just be aware that head scale probably won’t solve your problem automatically. Its a routing and or firewall config issue.
LetchLemon@lemmy.blahaj.zone 1 day ago
Thankyou for the insight. I have started looking at headscale and there seems to be chatter about implementing a mullvad exit node which seems promising. Ill spin up a vps tomorrow and explore options. I also want to run it on my own hardware (its a use what i have on hand situation).