Comment on Any ideas on what is the reason for the first layer being shit?
spitfire@lemmy.world 4 weeks ago
Looks like the nozzle is too close (z-offset is wrong) or too much filament is extruded (flow rate is too high).
Comment on Any ideas on what is the reason for the first layer being shit?
spitfire@lemmy.world 4 weeks ago
Looks like the nozzle is too close (z-offset is wrong) or too much filament is extruded (flow rate is too high).
Trail@lemmy.world 4 weeks ago
I would guess the z-offset should be fine because for any other filament it works correctly.
I will try to print a test for determining the flow rate for this specific filament after my print is done. I am using the default Bambu settings at the moment, and didn’t have any issue on other filaments so far, but I guess it’s worth checking out.
spitfire@lemmy.world 4 weeks ago
Then it might be flow or inconsistent extrusion. Try doing calibration available in Orca (probably same thing in Bambu slicer).