Comment on Locked out of GL-AXT1800 admin panel after WireGuard route change
tatoko556@reddthat.com 1 day agoThank you, a short reset worked!
But how do I set up the routing correctly on the WireGuard router? What should the Target Address and Gateway be if my LAN is under 192.168.8.0/24, and my mobile client with the WireGuard client has a client IP of 10.0.0.2/24?
tychosmoose@lemmy.world 1 day ago
So you have a single mobile device connecting via wg, correct? Not a second network?
If so the only configuration you should need on the router are firewall rules to allow forwarding from wg to lan. I am guessing that’s what the second step in the GL-iNet help accomplishes. That’s what I would recommend trying.
If I was doing this on “normal” OpenWRT I would create a firewall zone wg, and allow traffic to/from it and lan.
On the client device you should be good to go without changes if AllowedIPs is set to 0.0.0.0/, ::/0 (sending all traffic through wg).
tatoko556@reddthat.com 1 day ago
thanks a lot