Comment on Using the LM311 comparator, as a faster replacement for LM741 in project
Tolookah@discuss.tchncs.de 1 week ago
What’s your schematic with the lm311 ? Input impedances, output impedance, voltages, etc
Comment on Using the LM311 comparator, as a faster replacement for LM741 in project
Tolookah@discuss.tchncs.de 1 week ago
What’s your schematic with the lm311 ? Input impedances, output impedance, voltages, etc
lordofflies@lemmy.ml 1 week ago
Same circuit with LM311 comparator Made this two hours back, going to go and simulate this in the lab now, will get back with results later.
Tolookah@discuss.tchncs.de 1 week ago
Looking at the datasheet for the lm311, the output is a transistor (I think it’s shown on your schematic), the reason you need a pull-up on it is because it has no bias or power. That will let it pull the voltage down. If you’re noting that it doesn’t rise fast enough, try making that 100k smaller, give it some more strength.
. The 741 on the other hand has a pair of transistors on the output stage, attached to +v and -v so it can push and pull the output