Neat. How much work was it? Any thoughts about doing a How-to?

It was a lot of work to get it to fit because it’s not actually that deep. I managed to make it work by installing a longer cable for the display (it was too big with it in the normal position) and getting a 90° power adapter to allow the door to close. The filament spool is positioned on top and goes through a printed tube. There is also a small hole to allow cables to go out from the back.

After all Said and done did you notice any print quality differences?

Yes, there was a big improvement. It stands under my window and the draft ruined a lot of prints. I struggled to print anything over 5 cm high.
Now the temperature inside is higher (temperature sensor inside says it’s 34 °C) and the humidity is about ~15% lower than the rest of the room. Print quality has improved a lot.