Comment on [Help request] How do I go about debugging my router?
Gonzako@lemmy.world 3 days agoI think I am behind a double Nat as I’ve tested your higher than 1024 port option and it hasn’t worked
Comment on [Help request] How do I go about debugging my router?
Gonzako@lemmy.world 3 days agoI think I am behind a double Nat as I’ve tested your higher than 1024 port option and it hasn’t worked
darkan15@lemmy.world 3 days ago
Well, if you are forwarding the ports from your home router, and you can’t reach it’s the most probable cause, if you are, that means that there is no public IP reaching your home router.
You could contact your ISP and confirm if this is the case, they could offer to assign a public IP for an extra fee, your only other option is to rent a cheap VPS and tunnel traffic between it and your home, but at this point you could also decide to host stuff on the VPS.
Gonzako@lemmy.world 3 days ago
Oh! I am actually not behind Nat as I did a traceroute towards my public ip and it only did one hop. So it’s seems to be the port forwarding in itself not working
bigredgiraffe@lemmy.world 3 days ago
To add some more info to what the others are saying, if your public IP address is in the range
100.64.0.0/10
(so between 100.64.0.0 and 100.127.255.255) then it is a CGNAT IP and you will not be able to make port forwarding/NAT work to/from the public internet because your public IP is not actually a publicly routable IP on the internet no matter what your ISP calls it. Hope that helps!darkan15@lemmy.world 3 days ago
Traceroute can be a good hint, another way to confirm is on your router config interface, there should an IP address, subnet and gateway it connects to, with these values you could also verify it depending on what IP ranges it shows.