Comment on Bubbles in molten filament?
marcos@lemmy.world 1 week ago
The bubbles are probably because your filament is moist, and are not related to the clogging.
If you have been printing with PLA for a while, the ABS it had originally shouldn’t be a problem. Look if the hot-end is clean, and if its heat dissipater has enough airflow. It’s quite hard to discover the cause of clogs, but I’d start there.
Kratzkopf@discuss.tchncs.de 1 week ago
Thanks, the part about ABS is a relief, I was worried I contaminated that thing for good. I will also take a look at the air flow and try to get a filament dryer.