Comment on Need help setting up my filament runout sensor on my Voxelab Aquila running Alex firmware
corodius@lemmy.world 1 year ago
it sounds like you need to invert the runout sensor detection, as it is triggering immediately.
Comment on Need help setting up my filament runout sensor on my Voxelab Aquila running Alex firmware
corodius@lemmy.world 1 year ago
it sounds like you need to invert the runout sensor detection, as it is triggering immediately.
Gorroth@lemmy.world 1 year ago
I already tried that, didn’t work. I increased the runout distance and sent some M412 commands to configure everything before a test print. It then seemed to work, but when I cut the Filament to simulate a runout it didn’t work. Sending the sensor back if I can’t get it to run this weekend