Comment on Prints appear to be lifting in one corner.
Setiyeti93@lemmy.ca 1 day agoThanks for the advice.
The heated bed was set to 70, however I’ve realised it’s actually only for the initial layer where it drops to 60.
Do you think I should try to consistent 60 or 70?
I do have an IR thermometer so I will give it a thorough probe…
As for an enclosure… This is something I remember planning when I initially got the machine years ago. Unfortunately one of the big selling points of the any cubic chiron was the enormous build plate! This means building of an enclosure for it eats up quite a bit of space 😂 It’s currently situated underneath a desk with three of the four sides covered, but I shall make a curtain to cover the front.
N.b. I can’t ever recall using any significant amount of the enormous build plate… So when I look to buy a new printer, I’ll definitely go with something a lot smaller, with an enclosure.
FuglyDuck@lemmy.world 1 day ago
its not uncommon to start high and come down a bit. PLA+ typically has it’s glass transition right around there, and you do not want to be above that.
check the actual surface temperature, if you can, since most beds, the surface will be cooler than what the probe under it is saying, but typically you want 55ish for printing temp.
another way you can check is to just set some scrap plastic of the same filament on it. If it goes rubbery and pliant, its too high. the tricky thing about glass transition is it’s not a single point, it’s more of a small range, where, approaching it, it starts getting noticeably softer until it stops changing as much.