Comment on Prints appear to be lifting in one corner.

hades@feddit.uk ⁨1⁩ ⁨month⁩ ago

• Setiyeti93@lemmy.ca ⁨1⁩ ⁨month⁩ ago

  I do usually give it a quick scrub, maybe not the best technique… But I blightly scrub the surface with a sponge… admittedly using some mild soap and water, then wiping it down with plain water. And finally drying with paper towel. I also make sure the bed preheats beforehand to drive off any remaining moisture.

  As other comments of suggested I will try using some IPA 99. If it continues this way I likely use some glue as well.

  source

  • hades@feddit.uk ⁨1⁩ ⁨month⁩ ago

    Yeah so I’ve struggled with warping too and for me by far the best bang for the buck was alcohol. I’ve never tried glue or hairspray or any actual adhesives.

    source
  • CmdrShepard49@sh.itjust.works ⁨1⁩ ⁨month⁩ ago

    You might try hairspray over glue as it’s super easy to get even coverage and is significantly cheaper that glue especially with all these expensive “specialized” printing glues that have come out recently.

    source