Comment on Prints appear to be lifting in one corner.
brillotti@lemmy.world 2 days ago
Try raising the bed temperature a little, and maybe add brims to your prints for better bed adhesion. Another thing to try if the above doesn’t work is glue.
Comment on Prints appear to be lifting in one corner.
brillotti@lemmy.world 2 days ago
Try raising the bed temperature a little, and maybe add brims to your prints for better bed adhesion. Another thing to try if the above doesn’t work is glue.
Setiyeti93@lemmy.ca 2 days ago
Thank you very much for your response, and the link.
I had a look at my settings for bed temperature. I currently have the bed temperature at 70 degrees. However it appears that is initial bed temperature. It then drops to 60. Thankfully I want to print a few more of the exact same model, so I will reprint on a steady 70.
I will give the bed to thorough clean with 99% IPA. A next perhaps a coating of PVA.
Thx again!
CmdrShepard49@sh.itjust.works 1 day ago
Maybe try using 70% or 91% IPA. 99% might evaporate too fast to give it a good cleaning.