It was a frustrating experience. On the one hand, I really really really wanted the tool manufactured in the US. However, if I went the US route, I would have never sold one piece because it was just too expensive. It wasn’t an easy decision to go to China. After doing a couple runs, I had recouped my investment plus a little pocket change to put some 'taters on the table. I learned a lot on the way tho. You hear people say, ‘You outta patent that’, but the process is not that easy. At any rate, at least I can say ‘Been there, done that, got the t-shirt. No better or worse for the exercise.’