Comment on Gyroid infil appreciation post

CarlosCheddar@lemmy.world ⁨1⁩ ⁨year⁩ ago

• Jtskywalker@lemm.ee ⁨1⁩ ⁨year⁩ ago

  This is PETG also - it makes for super sturdy prints.

  source

  • LazaroFilm@lemmy.world ⁨1⁩ ⁨year⁩ ago

    4 walls 30% gyro infill. Strong as a rock.

    source

    • FuglyDuck@lemmy.world ⁨1⁩ ⁨year⁩ ago

      Increase the extrusion width on the infil as well- it’ll print the same amount of material, butb juice the strength phenomenally. 150% of default (which is usually at or near nozzle width,) for appearance parts. 200% for strength

      source

      • Jtskywalker@lemm.ee ⁨1⁩ ⁨year⁩ ago

        That’s a good tip - I haven’t tried that yet. I’ll give it a shot next time I need something sturdy

        source