Comment

Lower the Z offset. Not by too much, or it’ll scratch the bed.

“Everything is failing” is not useful info at all.

Sort:hotnew top

stangel@lemmy.world ⁨1⁩ ⁨day⁩ ago
Maxwell asked if it was all prints failing it just the benchy. OP replied “everything is failing”.

source
mineralfellow@lemmy.world ⁨1⁩ ⁨day⁩ ago
Ok, I am having trouble uploading the video. Anyway, all of the prints will be fine up to a point, then detach. The nozzle is colliding with the models. In some cases, I can see the model being pushed down on one side or other by the nozzle before it detaches.

source
- maxwells_daemon@lemmy.world ⁨1⁩ ⁨day⁩ ago
  Yeah, if the nozzle is hitting the part, then it’s very likely a cooling issue. If an steep overhang isn’t cooled properly, it’ll curl upwards.
  
  Either you’re printing too hot, or the fan is too slow or failing. For PLA, you can leave the fan at 100% after the first or second layer, and print between 195 and 205°C. Printing too fast also means the fan may struggle with the amount of hot plastic.
  
  Can you paste your slicer settings?
  
  source