Comment on Need help setting up my filament runout sensor on my Voxelab Aquila running Alex firmware

Swim@lemmy.ca ⁨1⁩ ⁨year⁩ ago

• Gorroth@lemmy.world ⁨1⁩ ⁨year⁩ ago

  It’s this one:

  SUNLU 3D-Drucker-Gehäuse, konstante 3D-Drucktemperatur für ABS 3D-Drucker-Filament, Ender 3/3 PRO 3D-Drucker-Gehäuse, bietet viel Platz, feuerfest, Größe 650 * 550 * 750mm amzn.eu/d/dPwi2Uv

  It’s actually made for 3D printers

  source

  • Swim@lemmy.ca ⁨1⁩ ⁨year⁩ ago

    Very cool, I didn’t know that was a thing

    source

    • Gorroth@lemmy.world ⁨1⁩ ⁨year⁩ ago

      I also learned about them just recently. I had to move my printer over in my homeoffice and I was a bit concerned about noise and fine dust, so I looked up what I can do and stumbled across these. Not doing that much about noise, but as I switched all of my printers fans to Noctua ones that’s not a big problem. Big advantage is my prints look cleaner and stick better to the build plate, as it is always at constant heat, even if I open my windows. And I at least think the dust stays in there, as there is no more „3D printer smell“ if you get what I mean :D Can absolutely recommend this.

      source