Comment on Prototype of RTX 5090 Appears With Four 16-Pin Power Connectors, Capable of Delivering 2,400W
justJanne@startrek.website 4 weeks agowhen you do need power you need a special circuit.
We also have a standard socket and a high power socket.
Expect our normal outlets provide 230V 16A 3.5kW (3kW sustained) and the typical high power outlets outlets provide 400V 30A 11kW or 400V 60A 21kW.
Which is why typical electric stoves here use 11kW and typical instant water heaters use 21kW.
Though probably the most noticeable advantage is in electric car charging.
InverseParallax@lemmy.world 4 weeks ago
Yeah, in Sweden I charge our plug in hybrid off 240, it’s pretty quick and you can use any outlet.
The giant round connectors are weird BTW, with all the holes, trying to sort that out for faster charging.
I don’t think we should run 100+ volts everywhere, we need to standardize on lvdc in most places (basically usb-c or so) with 100v only in kitchens and places you need it, because it’s more dangerous and can cause fires more easily.
justJanne@startrek.website 4 weeks ago
That’s a common misconception. It’s the Amps that cause fires, not the voltage.
The 5090 uses 600W, at 12V that’s 50A, but at 120V that’d only be 5A and at 240V only 2.5A.
50A melts cables and burns your PC down, 2.5A won’t. The only risk of higher voltages is that they can jump across small air gaps much easier.
InverseParallax@lemmy.world 4 weeks ago
No it’s not, I’m an ee.
P = I^2R, so power doubles with the current, while it’s linear to voltage.
This means current causes more heat dissipation in the wire, which has risks, potentially fire if you really go too far, this is why breakers trip.
But what really causes fires (again, outside of crazy overcurrent) is Arcing, from basically either bad connections or bad insulation, OR, from an inductive load that gets disconnected, so the current tries to stay constant in the coils, which leads to massive voltage spikes.
justJanne@startrek.website 4 weeks ago
The recent technology connections video cited a lot of statistics on this topic, and at least household fires are primarily caused by overcurrent, not by arcing.
You probably know more than me — I only studied compsci with ee as minor — but from my personal experience, I’ve seen many cases where overcurrent caused damage, burns or fire, but I can’t remember a single case where arcing caused actual damage.
Even in cheap chinesium powerstrips, the primary cause of fires is overcurrent due to AWG 22 copper clad iron wire, not arcing. (Though the switches usually weld themselves together after a few dozen uses).