Comment on I fixed my air conditioner!
evasive_chimpanzee@lemmy.world 2 weeks ago
I’ve definitely got a soft spot for any electromechanical appliances. Computers have gotten so cheap that every appliance built now runs on them, but it’s much hard (for me, at least) to do anything about it when one stops working.
-
My chest freezer stopped working, and i was able to put in a new relay for $2. The circuit diagram made it easy to diagnose with a multimeter. Oddly enough, i had to buy a 10 pack, so i likewise have a bunch of spares I’ll never need.
-
My dishwasher stopped working, and the manual specifically showed which wires to connect to to test resistance of each component to see if anything needed to be replaced. It turned out that the float was gunked up, so it read as having enough water even though it didn’t.
-
My fridge ice maker stopped working, and I just had to stick in a jumper wire to put it through a test cycle that immediately made it clear what was going wrong (a short), and i was able to fix it.
This is all in contrast to my clothes washer that runs on a computer, and it gives me an error message that basically just means “it’s not draining right”, and there’s like 8 potential causes, and I’ve tried to address them all, but it’s still get the error message.
limelight79@lemm.ee 2 weeks ago
I have to admit I did find one nice thing about our electronically driven washer. We bought a new washer and dryer when we moved to this house, and the washer was fine for a few weeks, then errored out on a load of delicates. Tried restarting it, same issue. Unplugged it, plugged it back in, same issue. I was starting to get upset when I realized that the “cold” water hose was hot. The handles on our valves are reversed. The washer realized it was filling with hot water and gave an error instead of ruining the clothes. Swap the hoses, and it has worked perfectly since.
Other than having to replace the tensioner on the dryer’s belt, they’ve been totally reliable.
Our dishwasher died a year or two ago. I realized it wasn’t circulating the water, so I replaced the pump. Unfortunately that didn’t fix the issue, so I wasted over $100 on the pump. Likely it was the transformer or controller for that pump, but I was tired of not having a dishwasher and replaced it. I still have the new pump, I should ebay it…
evasive_chimpanzee@lemmy.world 2 weeks ago
One of my friends had their water hookups backwards, too, and they had no clue until I checked after they complained to me about how all their clothes were shrinking despite only ever washing on cold and hang drying. Sounds like a nice feature to have a sensor in there.
limelight79@lemm.ee 2 weeks ago
Yeah. I had noticed it seemed steamy in the washer after loads finished, but I didn’t put it together until the washer caught the issue.