Comment on shearing on outer walls with PETG in a bambu p1p
stealth_cookies@lemmy.ca 3 weeks ago
That the default petg profile? Bump up your temperature by 10C and try again. Their PETG profile is too cold for the flow rate.
Comment on shearing on outer walls with PETG in a bambu p1p
stealth_cookies@lemmy.ca 3 weeks ago
That the default petg profile? Bump up your temperature by 10C and try again. Their PETG profile is too cold for the flow rate.
muusemuuse@lemm.ee 3 weeks ago
I actually lowered it to 250 and turned off the fan and it didn’t help.
stealth_cookies@lemmy.ca 3 weeks ago
Wrong way to adjust, try printing at 265 and keep the part fan on ( aux fan off).
muusemuuse@lemm.ee 3 weeks ago
the spool says not to exceed 250
roofuskit@lemmy.world 3 weeks ago
He’s the thing about temperature sensors, they vary.
stealth_cookies@lemmy.ca 3 weeks ago
Run a temp town if you are worried about it, but i run all PETG at 265 on my P1S. 255 will tear like you show and print matte which means it isn’t properly melted.