Comment on This is the back of my 10" Mini server rack -- Custom made 3D printed power modules for each server
bootstrap@lemmy.dbzer0.com 16 hours ago
How is the power wired exactly? It looks like youve piggy backed off each cable before it, meaning the first cable is carrying the load from all after it which it usually isnt designed to do, should be fine if appropriately rated to the equipment.
Looks mint!
Legion739@piefed.zip 16 hours ago
Yea each one runs through the previous module, so all the power goes through the first module.
IEC 13/14 connectors are rated for 10A (2300 W at 230 V) which isn’t much lower than what you can run through your wall outlet.
That’s very high, to give you an idea the 6 things I have plugged in draws ~240w, so I could chain up ~60 mini PC’s and only then would I be over the ~2300w limit.
I do now mention this in the Safety section of my “How to build this” write up
bootstrap@lemmy.dbzer0.com 15 hours ago
Looks like youve done your research!
Depending on the kettle model, most draw just under 10A these days. General household outlets (at least in australia) are only rated for 10A anyway.
Ive used hundreds of kettle leads in my time and never seen one used for an actual kettle funnily enough