Comment on Help wanted undextrusion and stuck filament

• InEnduringGrowStrong@sh.itjust.works ⁨1⁩ ⁨week⁩ ago

  Not necessarily since the initial layers don’t have the space to be squished properly, subsequent layers can show the same problem, except they’re too close to the previous layer instead of the bed itself.

  That said, the picture didn’t load before but now it does.
  Qith the picture, this looks kinda like wet filament to me where it’ll kinda bubble here and there.
  I’ve also spent way too much time hunting down underextrusion what was ultimately just the filament that had a weird undersized diameter like 1.6mm.
  Diameter that’s off but consistent through the roll can be compensated for in the slicer, inconsistent diameter not so much.

  original