I would say that depends on you, your printer and the used filament.
On my Voxelab Aquila out of the box with official slicing Software I could print PLA without issues, but with TPU it would have been impossible. Now I use Astroprint.com for slicing where I control print settings in more detail than it would be possible with Voxelab’s slicer. So that was the first step to take. Also I upgraded my printer to DirectDrive and DualGearExtruder. I then needed a new fan shroud, because the one I used before didn’t fit anymore. Then I had to learn about e-steps, because somehow I went into Unterextrusion (after switching to the dualgear Extruder you need to get the e-steps set new depending on the new extrudergear thickness. Luckily it was mentioned on the package it came in). Then the TPU started wrapping around the extruder gears. Turns out I printed too fast and so on…
Long story short. Depending on your printer, I would suggest at least switching to DirectDrive if your printer doesn’t have it. Also print very slowly, like 20mm/s slowly.
Gorroth@lemmy.world 10 months ago
I would say that depends on you, your printer and the used filament.
On my Voxelab Aquila out of the box with official slicing Software I could print PLA without issues, but with TPU it would have been impossible. Now I use Astroprint.com for slicing where I control print settings in more detail than it would be possible with Voxelab’s slicer. So that was the first step to take. Also I upgraded my printer to DirectDrive and DualGearExtruder. I then needed a new fan shroud, because the one I used before didn’t fit anymore. Then I had to learn about e-steps, because somehow I went into Unterextrusion (after switching to the dualgear Extruder you need to get the e-steps set new depending on the new extrudergear thickness. Luckily it was mentioned on the package it came in). Then the TPU started wrapping around the extruder gears. Turns out I printed too fast and so on…
Long story short. Depending on your printer, I would suggest at least switching to DirectDrive if your printer doesn’t have it. Also print very slowly, like 20mm/s slowly.